Note: Coil and injector wire colors vary slightly between USDM and JDM/CSX versions.
If you are reading this for a standalone build: k20z3 ecu pinout
| Pin | Wire Color | Function | Notes | |-----|------------|----------|-------| | C1 | Wht/Red | APP Sensor 1 (Accel Pedal Position) | Signal | | C2 | Red | APP Sensor 2 | Redundant signal | | C3 | Brn | APP Sensor 1 Ground | | | C4 | Grn | APP Sensor 2 Ground | | | C5 | Blu/Red | APP Sensor 1 +5V Ref | | | C6 | Yel/Wht | APP Sensor 2 +5V Ref | | | C7 | Pur | Primary O2 Sensor (Air/Fuel Ratio – wideband) | LAF sensor | | C8 | Grn/Red | Primary O2 Heater Control | Ground-side switching | | C9 | Blu | Secondary O2 Sensor (post-cat) | Narrowband | | C10 | Red/Blk | Secondary O2 Heater Control | | | C11 | Wht/Blk | MIL (Malfunction Indicator Lamp – Check Engine) | Ground output | | C12 | Grn/Yel | Tachometer Output | Signal to cluster | | C13 | Wht/Blu | CAN-High (OBD-II communication) | | | C14 | Yel/Blu | CAN-Low | | | C15 | Pur | K-Line (ISO 9141-2) – older diagnostics | | | C16 | Grn | A/C Pressure Switch Input | | | C17 | Red | Clutch Pedal Position Switch (starter interlock) | | | C18 | Blu/Yel | Immobilizer Control Unit (communication) | | | C19-C48 | – | Various: VSA, EPS, ABS, cruise control, cooling fan high speed, A/C request, etc. | Highly model-specific | Note: Coil and injector wire colors vary slightly
Note: Honda made minor pin changes in 2009 (facelift). Below is the universal USDM 2006-2008 standard. We will denote any major 2009+ differences. Below is the universal USDM 2006-2008 standard
Note: Pinout numbering can be seen on the wire side of the connector by lifting the white plastic lock. Connector A (White - 44 Pins)