Make Sure There Are No Obstructions or Debris Inside the Printer. Power the Printer Off, Remove and then Reinstall the Fuser Unit, Xeroxhttps://www.support.xerox.com
Scraps of paper or debris stuck in the transfer module (Area 2a or 2b) or inside the fuser unit itself. xerox 010-321
The fuser unit or the Area 2 drawer may not be fully seated or locked into place. Make Sure There Are No Obstructions or Debris
The Xerox error code typically signals a Fuser Exit Sensor Static Jam . This is a common issue for several Xerox DocuColor and WorkCentre models where the machine detects paper failing to reach or exit the fuser unit properly. The Xerox error code typically signals a Fuser
The fuser operates at extremely high temperatures (typically 180–220°C or 356–428°F). Always power off the machine and wait at least 30–45 minutes before touching the fuser unit. Severe burns are possible.
Sometimes, the error is a transient logic lock.