Hard Reset Ruckus Wireless R320 !!install!! -

Maybe you bought a used R320 off eBay with a stubborn previous owner’s config. Maybe you’ve locked yourself out of the CLI. Or perhaps the AP is stuck in a boot loop, blinking its power LED like a distressed distress signal. When SSH refuses and the web interface laughs at your password attempts, there is only one solution left:

Connect your RUCKUS R320 to power via Ethernet (PoE). Do not use a DC power adapter unless specified; PoE is standard. Wait for the status LED to settle. It usually flashes green/amber during boot. Let it run for about 60 seconds.

: Press and hold for at least 10 to 15 seconds .

Every RUCKUS R320 has a physical reset button. This is the most reliable method, especially if you cannot access the web interface (UI) or SSH. Hard Reset RUCKUS WIRELESS R320

A "Hard Reset" (often called a Factory Reset) is not the same as a simple power cycle (reboot).

Specifically, this process will:

: Use a straightened paperclip or similar thin object to press and hold the reset button for at least 10 seconds Maybe you bought a used R320 off eBay

: On the R320, the reset button is a small pinhole located on the rear of the device, typically near the Ethernet (PoE IN) port.

You should perform a hard reset if:

Use this method if you still have the login credentials and network access. When SSH refuses and the web interface laughs

Once the reset is complete, you can access the AP's internal web interface to reconfigure it: Default IP Address 192.168.0.1 Default Username Default Password Unleashed R320 Access Point Quick Setup Guide

To perform a hard reset on a RUCKUS R320 Access Point (AP), you can use either the physical reset button or the web interface. A hard reset will erase all custom configurations and return the device to its . 🛠️ Method 1: Using the Physical Reset Button