Amada Digipro Manual Page

| Interval | Task | Manual Page Ref (Typical) | | :--- | :--- | :--- | | | Clean the linear scales (X, R, Z axes). | Section 6.2 | | Weekly | Check hydraulic oil level (ISO VG 46). | Section 7.1 | | Monthly | Inspect ram gibs for wear. | Section 8.3 | | Quarterly | Perform "Deadweight Test" to recalibrate tonnage sensor. | Section 9.0 - Requires service password |

Press SINGLE CYCLE . Use the manual’s "Slow Bend Speed" adjustment knob to creep up on the angle. amada digipro manual

: The measured angle is transmitted via an infrared interface to the machine's NC, which then automatically generates program corrections. Standard Calibration | Interval | Task | Manual Page Ref

Pressing the moving square of the protractor against its stop. | Section 8

: If a drop occurs or measurements are inaccurate, calibration usually involves placing the unit on a flat surface, holding